Subject	Dynamic Torsional vibrations & driveshaft whip >
Posted by	ZUL8TR on September 11, 2006 at 5:49 AM
	This message has been viewed 158 times.
In Reply To	What problems? (n/m) posted by TTFairladyZ on September 10, 2006 at 06:16 PM
Message	required the addition of the frame mounted center support bearing to reduce these to acceptable levels. ZUL8TR in Orlando,FL
Follow Ups	getting anew driveshaft - yosha 12:03:11 09/10/06 I just installed my Z1 platinum 1 piece driveshaft last Thur - TTFairladyZ 12:46:46 09/10/06 I was actually looking at this company's: - rufflez 12:51:36 09/10/06 I'm happy with my 1pc Steal AMZ DS. If needed, I'll but - Neogenesis 12:59:44 09/10/06 how did you pinpoint the driveshaft? - mousersix 13:59:57 09/10/06 Re: how did you pinpoint the driveshaft? - yosha 14:02:11 09/10/06 I've had the Z1 driveshaft for close to 3 years.... - 92naz32 15:25:29 09/10/06 What ever DS you use replace the rear tranny isolater mount> - ZUL8TR 17:56:03 09/10/06 What problems? (n/m) - TTFairladyZ 18:16:12 09/10/06 Dynamic Torsional vibrations & driveshaft whip > - ZUL8TR 05:49:40 09/11/06
Post a Followup	You cannot reply to this message because you are not logged in.