Subject	you can MIG weld it
Posted by	freak152000 on September 10, 2006 at 10:51 AM
	This message has been viewed 82 times.
In Reply To	Just go with the bolt-in. posted by DVDBURN (MD) on September 09, 2006 at 11:55 AM
Message	you just need to make sure that you have the proper wire. if its 4130 use 4130 wire. same thing with TIG you have to have the proper filler rod. but with both welding methods it is suggested that you preheat it to about 200*F so that it doesn't get too stressed from the welding.
Follow Ups	Need a Roll Bar? Keep reading ---->> - Eishozzzz 06:04:57 09/09/06 I've seen these guys before and was wondering how good they - spyhunterTT(nj) 08:09:19 09/09/06 Why get it then if you're gonna do bolt? Weld is the way to - Neogenesis 11:08:06 09/09/06 I haven't purchased anything yet. - spyhunterTT(nj) 11:31:46 09/09/06 Just go with the bolt-in. - DVDBURN (MD) 11:55:08 09/09/06 you can MIG weld it - freak152000 10:51:22 09/10/06
Post a Followup	You cannot reply to this message because you are not logged in.