Subject	I've seen these guys before and was wondering how good they
Posted by	spyhunterTT(nj) on September 09, 2006 at 8:09 AM
	This message has been viewed 62 times.
In Reply To	Need a Roll Bar? Keep reading ---->> posted by Eishozzzz on September 09, 2006 at 06:04 AM
Message	are. I'd prefer a bolt in option rather than weld (easier diy). Alex bork bork bork! Zengineer - ""...300zx is arguably the best, and has been almost universally admired by designers for its refinement, elegant surface development and painstaking detail design; and to think that some teenager will slap on a $150 Veilside front bumper on it 10 years from now is nauseating"
Follow Ups	Need a Roll Bar? Keep reading ---->> - Eishozzzz 06:04:57 09/09/06 I've seen these guys before and was wondering how good they - spyhunterTT(nj) 08:09:19 09/09/06 Why get it then if you're gonna do bolt? Weld is the way to - Neogenesis 11:08:06 09/09/06 I haven't purchased anything yet. - spyhunterTT(nj) 11:31:46 09/09/06 Just go with the bolt-in. - DVDBURN (MD) 11:55:08 09/09/06 you can MIG weld it - freak152000 10:51:22 09/10/06
Post a Followup	You cannot reply to this message because you are not logged in.