Subject	I am going to be using an OEM electric fan that
Posted by	AzHeat on September 08, 2006 at 2:55 PM
	This message has been viewed 33 times.
In Reply To	We've come to the conclusion that on the Z32, there is posted by Ash's Z on September 08, 2006 at 01:28 PM
Message	flows 4500 CFM. That is 50% better than a Spal. I will also use the DC control unit that will keep the coolant temps at constant instead of cylcing on and off. On my Z the engine ran most efficent around 190-195.
Follow Ups	Question on breaking in an engine - mousersix 11:09:51 09/08/06 Just don't slip the clutch and it'll be fine. (n/m) - Dustin 11:26:47 09/08/06 Incorrect on clutch break in. - BigTDogg (MA) 11:28:07 09/08/06 That's a lot of oil changes - dummy76 11:30:01 09/08/06 I know Joe(NoVA) posted his break in routine - BigTDogg (MA) 11:37:46 09/08/06 I changed oil after a 20-minute idle, then 100, 200, 500, - Scotts94z32 11:49:22 09/08/06 Re: I changed oil after a 20-minute idle, then 100, 200, 500, - dummy76 11:50:56 09/08/06 Hopefully just science, forensic would indicate a dead motor (n/m) - BigTDogg (MA) 12:10:27 09/08/06 It does happen ;-) (n/m) - Scotts94z32 12:35:42 09/08/06 I've heard, easy break in for reliability, hard break in - rufflez 11:33:46 09/08/06 interesting... - mousersix 11:53:37 09/08/06 500 miles stop/go driving (have to shift, higway doesn't - BigTDogg (MA) 12:15:15 09/08/06 Clutch Break in Question - Boztonz32 12:24:47 09/08/06 I wouldn't think any chatter is normal on a full disc - BigTDogg (MA) 12:46:22 09/08/06 I've read that as well.........just seems so - dallaz (My name not the city) 11:50:54 09/08/06 I read that too, but also I know of a couple - mousersix 12:37:40 09/08/06 Use an old clutch to break in the motor... - CaliguyPurdue 12:00:10 09/08/06 I broke-in my engine while running it as I normally would - Ash's Z 12:50:19 09/08/06 Off topic, are the new fan shrouds ready yet? - Woody75 (Denver) 13:12:04 09/08/06 We've come to the conclusion that on the Z32, there is - Ash's Z 13:28:17 09/08/06 I am going to be using an OEM electric fan that - AzHeat 14:55:43 09/08/06
Post a Followup	You cannot reply to this message because you are not logged in.