Subject	Re: tool question....
Posted by	Black_93_300ZX on September 03, 2006 at 10:07 PM
	This message has been viewed 41 times.
In Reply To	tool question.... posted by WAGGZ on September 03, 2006 at 09:32 PM
Message	Ah, if I do remember that was a b*tch to get to... I think I went through the wheel well if I recall correctly. Going at it from below is nearly impossible and above from the engine bay gives about the same chance. Try removing the driver's side front wheel and getting at it from there, I doubt you'll need the extension. Either way, good luck. :) -Tom
Follow Ups	tool question.... - WAGGZ 21:32:26 09/03/06 Just stronger and doesnt flex as much.. - Spddracer 21:36:39 09/03/06 cool, thanx (n/m) - WAGGZ 21:43:00 09/03/06 Never known drives to flex - 240Z FeO2 22:07:07 09/03/06 well I already have a 10" and three 3" extensions. - WAGGZ 22:17:31 09/03/06 Alright then. By my count three 3" and one 10" extension - 240Z FeO2 22:36:36 09/03/06 I tried with the extensions I have but wouldn't come close. - WAGGZ 22:46:20 09/03/06 New engine. Cool. (n/m) - 240Z FeO2 00:33:55 09/04/06 While your picking out your tools grab a 14mm swivel socket - Turbodog (CT) 06:46:41 09/04/06 Re: tool question.... - Black_93_300ZX 22:07:16 09/03/06 Raise the front of the engine a bit with a jack to make it - MidLifeZ (DFW) 07:40:46 09/04/06
Post a Followup	You cannot reply to this message because you are not logged in.