Subject	do it yourself for $120
Posted by	jackel on August 20, 2000 at 8:01 PM
	This message has been viewed 54 times.
In Reply To	Haven't even owned it a week yet>>> posted by David90NAFun on August 20, 2000 at 07:47 PM
Message	take a dremal tool and grind away some of the metal on the intake to expose the screw then switch them out.Just be carefull
Follow Ups	Haven't even owned it a week yet>>> - David90NAFun 19:47:01 08/20/00 Same thing happened ot me - Mike@ZSpeed 19:49:34 08/20/00 do it yourself for $120 - jackel 20:01:50 08/20/00 1st thing to do is get an independant mechanic who - toyluvr 20:09:30 08/20/00 Re: 1st thing to do is get an independant mechanic who - David90NAFun 20:41:01 08/20/00 independants are cheaper per hour (normally), usually - toyluvr 21:20:39 08/20/00 Re: independants are cheaper per hour (normally), usually - David90NAFun 22:17:33 08/20/00 Same thing with me>> - NA2+2GrayZ 20:18:56 08/20/00 Yea, try O2 sensors, TPS, cleaning TB's too... (n/m) - ZX-infinity (Dallas) 22:36:47 08/20/00 pull each ignition coil connector one at a time to find out - Bernie 21:22:22 08/20/00 where is the injector connector?? - David90NAFun 22:24:24 08/20/00 check out the injector replacement tech at www.ttaz.org. - Bernie 07:21:01 08/21/00 It's DIY job for sure. - ImTheDevil 07:24:14 08/21/00 never take your Z to the dealer - rocketZ 09:31:40 08/21/00
Post a Followup	You cannot reply to this message because you are not logged in.