Subject	It's not ideal, but the alternative is machining the housing
Posted by	300zx90 (CO) on August 16, 2006 at 4:12 PM
	This message has been viewed 36 times.
In Reply To	Question about GT28R posted by gclasse on August 16, 2006 at 04:01 PM
Message	to provide clearance for the divider on the downpipes. I left the housings alone and instead removed the divider from the downpipes (Note you have to weld the holes shut that are left behind from the divider fasteners). I have no idea if the effect of the gap in the cast divider is significant. ________________________________________ NA to TT, starting from the ground up... Proper check valve inspection per the FSM...
Follow Ups	Question about GT28R - gclasse 16:01:18 08/16/06 It's not ideal, but the alternative is machining the housing - 300zx90 (CO) 16:12:51 08/16/06 just take out the divider in the Super splits.. - Shawn300zTT GT28R MD 16:16:23 08/16/06 the -4 has them, the -1 variant does not (n/m) - Guapo 16:55:29 08/16/06
Post a Followup	You cannot reply to this message because you are not logged in.