Subject	Thanks for the input guys. Im going to give Ultimate Z a
Posted by	ENVYMYZ on August 15, 2006 at 9:09 AM
	This message has been viewed 36 times.
In Reply To	At a minimum you've got some bent suspension components... posted by Kenny on August 15, 2006 at 08:53 AM
Message	call today but judging by the handholding that I had to do just to get my car done in 2 months, I doubt Im going to get a straight answer. Based on the alignment specs, what would you guys say is bent? I dont know much about suspensions. Tension rods? Control arms? I have no clue :/ The rear subframe was replaced with a low mileage subframe from a 94. Id like to get this taken care of asap. "Losers always whine about doing their best, Winners go home and screw the prom queen" -Sean Connery "The sports car's sole purpose is to entertain the driver, and one very lucky passenger." - Unknown
Follow Ups	Good new and bad news - ENVYMYZ 22:36:42 08/14/06 Could you put those numbers in a table? - Kenny 00:20:13 08/15/06 Will do. Supposedly there was no frame damage. - ENVYMYZ 07:16:08 08/15/06 Ok here is the actual Data Table with all the specs: - ENVYMYZ 07:48:18 08/15/06 did the shop who checked you're alignment tell you if - 300MPH 08:07:10 08/15/06 I bought the one that Coz sells. I need the kit with the - ENVYMYZ 09:10:23 08/15/06 yeah, there's def something goobered on the right front - Guapo 08:46:12 08/15/06 At a minimum you've got some bent suspension components... - Kenny 08:53:50 08/15/06 Thanks for the input guys. Im going to give Ultimate Z a - ENVYMYZ 09:09:07 08/15/06 make sure to inspect suspension parts' mounting holes - ZEngineer 09:46:05 08/15/06
Post a Followup	You cannot reply to this message because you are not logged in.