Subject	I am using the rear driver's side plenum bolt. I used some
Posted by	MixManMash on July 31, 2006 at 11:38 PM
	This message has been viewed 47 times.
In Reply To	*shrug* posted by Ash's Z on July 31, 2006 at 08:04 PM
Message	good dielectric grease underneath to get a good ground contact with a ground contact washer (basically, it bites a little bit into the plenum and a little bit into the knock sensor). Never had a problem since. And the paranoid guy that I am, I ran codes often to check - mind you, I would have noticed the sudden loss of power.
Follow Ups	detonation sensor/knock sensor - DaRealDefaulTT 14:02:43 07/31/06 yes it will work, installing a new knock sensor in OEM - Atl300zxTT (Less Lazy) 14:07:50 07/31/06 THX engine is out! Your engine looks nice man! (n/m) - DaRealDefaulTT 14:11:12 07/31/06 Buy a new sensor & new subharness. - YugoBernie (NoVA) 14:11:20 07/31/06 yeah, what YB said.. - MidLifeZ 15:19:37 07/31/06 Be prepared to do some work. Do not put it in any other - Ash's Z 16:19:58 07/31/06 If the det doesn't monitor over 3600rpm,does it still retard - whatsthegoodword 16:28:29 07/31/06 After 3600RPM, it does nothing. (n/m) - Ash's Z 20:00:32 07/31/06 Why would he? - bankruptedz 17:10:32 07/31/06 I think you misunderstood what I meant.. - Ash's Z 20:02:42 07/31/06 I have relocated mine and I have not noticed any issue. - MixManMash 17:46:11 07/31/06 *shrug* - Ash's Z 20:04:17 07/31/06 I am using the rear driver's side plenum bolt. I used some - MixManMash 23:38:31 07/31/06
Post a Followup	You cannot reply to this message because you are not logged in.