Subject	I have relocated mine and I have not noticed any issue.
Posted by	MixManMash on July 31, 2006 at 5:46 PM
	This message has been viewed 42 times.
In Reply To	Be prepared to do some work. Do not put it in any other posted by Ash's Z on July 31, 2006 at 04:19 PM
Message	It has never cut back timing or gone into safety boost since. And yes I have a boost controller, but I have a relay setup to cut the boost controller out if the ECU wants it cut.
Follow Ups	detonation sensor/knock sensor - DaRealDefaulTT 14:02:43 07/31/06 yes it will work, installing a new knock sensor in OEM - Atl300zxTT (Less Lazy) 14:07:50 07/31/06 THX engine is out! Your engine looks nice man! (n/m) - DaRealDefaulTT 14:11:12 07/31/06 Buy a new sensor & new subharness. - YugoBernie (NoVA) 14:11:20 07/31/06 yeah, what YB said.. - MidLifeZ 15:19:37 07/31/06 Be prepared to do some work. Do not put it in any other - Ash's Z 16:19:58 07/31/06 If the det doesn't monitor over 3600rpm,does it still retard - whatsthegoodword 16:28:29 07/31/06 After 3600RPM, it does nothing. (n/m) - Ash's Z 20:00:32 07/31/06 Why would he? - bankruptedz 17:10:32 07/31/06 I think you misunderstood what I meant.. - Ash's Z 20:02:42 07/31/06 I have relocated mine and I have not noticed any issue. - MixManMash 17:46:11 07/31/06 *shrug* - Ash's Z 20:04:17 07/31/06 I am using the rear driver's side plenum bolt. I used some - MixManMash 23:38:31 07/31/06
Post a Followup	You cannot reply to this message because you are not logged in.