Subject	Huge 2nd, plus...
Posted by	300zx90 (CO) on July 20, 2006 at 10:29 PM
	This message has been viewed 67 times.
In Reply To	clean out the casting flash in the water passages (n/m) posted by Ebola (Edm'ish) on July 20, 2006 at 07:35 PM
Message	Skip the extrude hone, throttle bodies, and 2.5" intake. They're not needed for that power level. Gasket match all of the ports, especially the upper to lower intake, there's a lot of material to be removed there. Also update your profile, other suggestions will depend on what year you're working with. ________________________________________ NA to TT, starting from the ground up... Proper check valve inspection per the FSM...
Follow Ups	What else should be done to the motor? porting? - partymonster975 19:31:27 07/20/06 clean out the casting flash in the water passages (n/m) - Ebola (Edm'ish) 19:35:23 07/20/06 Huge 2nd, plus... - 300zx90 (CO) 22:29:34 07/20/06 I laughed pretty hard when i first saw your sig in the fsm. (n/m) - Ebola (Edm'ish) 23:31:41 07/20/06 If you are going to extrude hone the intakes - Broke_as_**** 20:00:41 07/20/06 so are you saying - partymonster975 20:32:40 07/20/06 Well what are you looking to do with this car? - Broke_as_**** 20:46:20 07/20/06 I plan to... - partymonster975 21:12:35 07/20/06 The "600" was probably the Z1 600 turbo - Broke_as_**** 04:56:15 07/21/06 Z1 GT600R kit also. - BigTDogg (MA) 08:43:21 07/21/06 so u think I should just... - partymonster975 10:46:27 07/21/06 IMO... - BigTDogg (MA) 11:48:29 07/21/06 Re: wow. ummmm - partymonster975 12:45:09 07/21/06 Ixnay on GPSnay - BigTDogg (MA) 13:06:46 07/21/06
Post a Followup	You cannot reply to this message because you are not logged in.