Subject	What else should be done to the motor? porting?
Posted by	partymonster975 on July 20, 2006 at 7:31 PM
	This message has been viewed 89 times.
Message	Hey, I am aiming for about 470hp on 93 oct. pump gas. (should be around 500 on race) and I want to know what else I should do to the enigne. I planned on adding CP forged Pistons (87.50mm 8.5:1). Will I need to bore my block to fit them, if so can you recommend a better piston what will be the stock bore? Also, ARP rod bolts and Eagle rods. I also planned to do an Extrude honed upper/lower plenums, is this a good idea? and also maybe go for 60mm throttle body conversion and 2.5" IC plumbing. What do you think. Is there anything else I should add or port or will I be safe enough already. I hear all you need is pistons so I think I should be safe but I also want to ask you guys. Anything else?
Follow Ups	What else should be done to the motor? porting? - partymonster975 19:31:27 07/20/06 clean out the casting flash in the water passages (n/m) - Ebola (Edm'ish) 19:35:23 07/20/06 Huge 2nd, plus... - 300zx90 (CO) 22:29:34 07/20/06 I laughed pretty hard when i first saw your sig in the fsm. (n/m) - Ebola (Edm'ish) 23:31:41 07/20/06 If you are going to extrude hone the intakes - Broke_as_**** 20:00:41 07/20/06 so are you saying - partymonster975 20:32:40 07/20/06 Well what are you looking to do with this car? - Broke_as_**** 20:46:20 07/20/06 I plan to... - partymonster975 21:12:35 07/20/06 The "600" was probably the Z1 600 turbo - Broke_as_**** 04:56:15 07/21/06 Z1 GT600R kit also. - BigTDogg (MA) 08:43:21 07/21/06 so u think I should just... - partymonster975 10:46:27 07/21/06 IMO... - BigTDogg (MA) 11:48:29 07/21/06 Re: wow. ummmm - partymonster975 12:45:09 07/21/06 Ixnay on GPSnay - BigTDogg (MA) 13:06:46 07/21/06
Post a Followup	You cannot reply to this message because you are not logged in.