| Heavy wetsanding working from 600, to 1000, to 1500, then finally 2000. Heavy polishing with a very thin rubbing compound. Plastic Polish/PlastX (not necessary, but helps) Several coats of a sealing wax to protect the new finish. The wax is essential to keeping the lens from deteriorating again. Baically, you sand and polish all the old deteriorated plastic so you have a new fresh, polished surface. I have great success with this method.
------------------------------------------------------------
bJammmin: i was thinking about masking off the bottom part (black on your lip) and painting mine flat black, caus it'll just keep getting scuffed forever
sfpearl300z: thats half the reason why i did it to mine
sfpearl300z: dont have to worry about any imperfections
sfpearl300z: cause it gets so much abuse
bJammmin: yeah dude so true goddamn
bJammmin: why are you a fucking genius
sfpearl300z: lol
sfpearl300z: you know what i hate?
bJammmin: whats dat yo
sfpearl300z: being so damn smart
bJammmin: LOL
sfpearl300z: i actually dont look too far into the lives of people on the forums
sfpearl300z: dont pay close enough attention
WickedPuddle: see
WickedPuddle: thats where you and i are different
WickedPuddle: i am on a whole different level of having no life
MiCHaeLkiH: i forked out 650 for my vibrating one
Fst300zx: its never been a problem until lately HAHA
sfpearl300z: lol
Fst300zx: itll fall everyonce ina while.. i just pump it a few times and it stays up
sfpearl300z: yeah
Fst300zx: haha damn this is a rough conversation
|
