Subject	I find blaming my draftsmen works well too. :) (n/m)
Posted by	CaliguyPurdue on July 10, 2006 at 1:48 PM
	This message has been viewed 32 times.
In Reply To	duuude, always blame it on the Technician (n/m) posted by ZEngineer on July 10, 2006 at 01:10 PM
Message
Follow Ups	Grill opening on a 99' JSPEC Fascia - pionkej 08:54:16 07/10/06 Here: - Ash's Z 09:43:26 07/10/06 about as good a response as anyone could ask for (n/m) - Atl300zxTT (Less Lazy) 10:03:30 07/10/06 not really, I don't even see tolerances on that dwg. :) (n/m) - ZEngineer 10:07:41 07/10/06 It's also under dimensioned ;) (n/m) - CaliguyPurdue 10:17:30 07/10/06 Total width on IC inlet duct is 9.5" =) (n/m) - Ash's Z 10:29:08 07/10/06 Now that I look again, it was not. "3.5" locks in - CaliguyPurdue 10:34:19 07/10/06 Yay for right triangles! (n/m) - turtleboy 12:11:44 07/10/06 Damn PITA Engineers!! ;) (n/m) - Z-Jay (Edmonton, AB) 12:07:17 07/10/06 Engineers are not a problem, it's the sloppy engineers! (n/m) - Technomancer 13:05:30 07/10/06 duuude, always blame it on the Technician (n/m) - ZEngineer 13:10:47 07/10/06 Hey, so long as you don't blame the Technomancer - Technomancer 13:25:04 07/10/06 I find blaming my draftsmen works well too. :) (n/m) - CaliguyPurdue 13:48:07 07/10/06 I've been a drafter for an engineer like that... - Broke_as_**** 14:09:02 07/10/06 Make it flow up hill, blame the Manager who changes his mind (n/m) - BigTDogg (MA) 14:11:14 07/10/06 Don't get PennStateZ started, jeeez :D (n/m) - BigTDogg (MA) 13:25:39 07/10/06 :bite: (n/m) - PennStateZ 16:53:35 07/10/06
Post a Followup	You cannot reply to this message because you are not logged in.