Subject	thanks! will do :) (n/m)
Posted by	mousersix (San Antonio) on July 08, 2006 at 3:01 PM
	This message has been viewed 32 times.
In Reply To	Correctamundo! Now go enjoy the hard hittin bass (n/m) posted by shirow on July 08, 2006 at 02:58 PM
Message
Follow Ups	Sound setup question - mousersix (San Antonio) 14:36:19 07/08/06 you need to hook up a dual voice coil sub in stereo - shirow 14:44:42 07/08/06 thanks for the quick reply! - mousersix (San Antonio) 14:53:10 07/08/06 Correctamundo! Now go enjoy the hard hittin bass (n/m) - shirow 14:58:34 07/08/06 thanks! will do :) (n/m) - mousersix (San Antonio) 15:01:15 07/08/06 Actually bridged/series should have the same output - just4kinks 15:08:17 07/08/06 When you wire them in series you increase the impedance and - shirow 15:19:44 07/08/06 But when you bridge, each amp channel sees only half of - just4kinks 15:26:00 07/08/06 But that does bring up a good point. His setup has a 4ohm - just4kinks 15:32:33 07/08/06 dunno, but ni[X]it's shoe makes for a great wheel chock - Guapo 14:49:31 07/08/06 fer shizzle (n/m) - mousersix (San Antonio) 14:54:45 07/08/06 I used to have 2 10" Alpine Type R's - TTFairladyZ 15:01:25 07/08/06 2nd, I was amazed at how well they sound - drmx 15:38:49 07/08/06 You left out the most important detail. What kind of box? - just4kinks 15:13:03 07/08/06 it's a sealed box that I made - mousersix (San Antonio) 16:21:21 07/08/06 Well, that bad news is that you're only getting 200W - just4kinks 16:48:28 07/08/06 thumbs down for RF amps for one :) lol - skateguy92 15:48:30 07/08/06 I used to have 2 12" sony explods - mousersix (San Antonio) 16:24:22 07/08/06 Ported box in any kind of hatch is gonna sound ridiculous. - mr_buttawurf(down-n-out) 16:37:11 07/08/06 if the original diagram is just fine then why no bass? - mousersix (San Antonio) 16:48:44 07/08/06 Is the amp powering up? Is the ground good? - mr_buttawurf(down-n-out) 16:56:04 07/08/06 Oh....you said no bass as in not enough.....duh-huh-huh-huh. - mr_buttawurf(down-n-out) 17:24:44 07/08/06 HEY! Look down here! The problem is.... - Jon'sZ 20:17:59 07/08/06 I have my SWS-1042D dropped down to 2 ohms like this: - zeddiea27 20:39:02 07/08/06 By the way, Its not your amp. My amp only puts out 200watts - zeddiea27 20:50:58 07/08/06 wire the sub in parallel, not series.... - Ghozt 22:59:29 07/08/06
Post a Followup	You cannot reply to this message because you are not logged in.