Subject	Please, please, please
Posted by	Technomancer on June 20, 2006 at 8:52 AM
	This message has been viewed 22 times.
In Reply To	AshsZ-II Ultimate Street Z Project: Engine mount fab > posted by Ash's Z on June 19, 2006 at 07:22 PM
Message	It's all intents and purposes! Nice work! - John
Follow Ups	AshsZ-II Ultimate Street Z Project: Engine mount fab > - Ash's Z 19:22:39 06/19/06 Nice work (n/m) - Joe(NoVA) 19:39:40 06/19/06 Sweet. How'd that video come out? (n/m) - BradZ (FL) 19:39:44 06/19/06 Really nice, but short. Waiting for dad to email it to me. - Ash's Z 20:01:07 06/19/06 very cool (n/m) - ZEngineer 20:57:07 06/19/06 Looking sweet (n/m) - Zepolcire 21:07:05 06/19/06 Very Nice!... - KevinsFairlady 21:32:01 06/19/06 I would be hestitant to use cast aluminum for a part - AzHeat 21:43:50 06/19/06 My back of the envelope structural analysis predicts the - shirow 22:01:39 06/19/06 I'm guessing it just needs to survive long enough until the - olyar15 23:13:09 06/19/06 Fresh cast aluminum can be broken up with a pair of pliers - CaliguyPurdue 23:19:46 06/19/06 So you were planning on forged Al? (don't answer if trade - shirow 23:45:24 06/19/06 Stamped steel would be sufficient. (n/m) - AzHeat 00:47:42 06/20/06 If bonded rubber/urethane will hold as long as it does, - Ash's Z 23:24:29 06/19/06 For a street car it may be fine. But high torque - AzHeat 00:43:12 06/20/06 The top bracket looks like the weakest part if it - AzHeat 01:09:13 06/20/06 ur an engineer and a good business man. lol (n/m) - dirtyjerZ 03:00:13 06/20/06 that's a hot fix! well done (n/m) - davidztt 07:09:17 06/20/06 Please, please, please - Technomancer 08:52:21 06/20/06 Geez! When are you going to fab up your own turbos? - aggiez32 14:02:22 06/20/06 didnt he? (n/m) - SpecNATT (Houston) 21:29:03 06/20/06
Post a Followup	You cannot reply to this message because you are not logged in.