Subject	motor oil to lube the o-rings. Insert by twisting about 15°
Posted by	doug8867 on June 19, 2006 at 4:25 PM
	This message has been viewed 45 times.
In Reply To	24 hours of Work Down the drain... posted by aztecz34 on June 19, 2006 at 03:50 PM
Message	back and forth until you get the upper o-ring to barely show if at all. If the injector doesn't appear to be sliding in easily put a bit more oil on your fingers and lube it and the lower o-ring some more. ps. Won't take you 24 hours this time. Always goes quicker the second time around.
Follow Ups	24 hours of Work Down the drain... - aztecz34 15:50:39 06/19/06 Vasoline. (n/m) - YugoBernie (NoVA) 16:03:25 06/19/06 oh that's your answer to everything! (n/m) - ZEngineer 16:15:10 06/19/06 he's a smart cookie (n/m) - charizma 16:21:53 06/19/06 Lubrication IS the key to life! - BOOZTD 3 21:57:28 06/19/06 There's always time for lube! (n/m) - TheSlimOne 23:16:35 06/19/06 motor oil to lube the o-rings. Insert by twisting about 15° - doug8867 16:25:19 06/19/06 Dremel. (n/m) - BummedOutMonkey 16:37:42 06/19/06 Word. (n/m) - BooZTT (Hawaii) 00:35:16 06/20/06 install the fuel rail, connect fuel lines without the plenum - apudapus 02:04:26 06/20/06 Hopefully you bypassed the throttle bodies. - 92fairladyz (Yokosuka, Japan) 04:30:17 06/20/06
Post a Followup	You cannot reply to this message because you are not logged in.