| I like some of the stuff being talked about today. Now that the fuel rails are winding up and hitting the streets, I've been working on my second and third major projects. As such, for the past 2 or 3 months, I've been really hitting the upper intake manifold. With out talking out my ass too much, I want to get ideas for what you guys would like in an upgraded turbo application. Right now, my key ingredients involved;
- plenum design; single or dual.
- throttle body design; single or dual.
- intake materials (cast/drawn/composite)
- level of mod required; bolt on to extensive.
- lets not forget about the IAA, Brake, Clutch, and Vacuum galleries
- PVC on or off? I've got quite a few 'leonardo' sketches and a few solids models for fluid dynamic analysis, but they are all fairly elementary at the moment.
So now I'm at the point where I need to choose a direction. I have a very very good idea on what I want, But I am asking you guys if there is anything you see I have not considered. What is missing? what are concerns? Thanks for any help.
Petz #3
 |
