|
It's working, a few things I'm curious about: This stuff says to remove before it dries on the label. HTF do you do that? I'm applying it to a 1/4 of my hood at a time & it's drying before I finish applying. I'm assuming there's no reason to polish it in, since there's no polish in it. So I'm just applying to the surface. Anyway, did the hood in 1/4ths & applying twice to each surface. Nice deep shine but.... OK, this is my whole procedure:
washed the car earlier this week with Meguire's car wash gell & all it's done is sit in the garage since, so it had a little dust on it.
used the 1st step in Meguire's 3 step
used Meguire's clay bar & Meguire's quik detailer as lube for it
used the 2nd step in Meguire's 3 step
had to walk away from the car for a few hours
used Meguire's quik detailer to remove any accumulated dust
used IBIZ as stated on the label... I used twice washed terrycloth towels & cotton applicators, washed w/ detergent, then straight water. Heat dried & then tumbled for 30 minutes to remove as much lint as possible. Now, with all that being said, while buffing off the IBIZ, there's like a greasy haze on the car... like subtle swirl marks, but they follow the trail of the towel, so I know it's not the car's finish. They settle out a little w/ time, but I can stand & watch them for a long time & it never 'dries' up or anything. I can see this under the flourecent light in my garage, I image the sun will make this stand out. I buffed each section w/ a new towel to make sure I wasn't just rubbing the old IBIZ around on the newer stuff. Really odd. This is why I don't like stepping away from stuff I've made money using previously... Overall the finish is nice, good depth & it turned my green a shade deeper too. =) Just concerned that I'm doing something wrong here. Don't need the GQ-DZIII upset w/ me!
Later
   |
