Subject	You don't want to use a box end wrench.
Posted by	Joe(NoVA) on June 18, 2006 at 6:44 PM
	This message has been viewed 24 times.
In Reply To	Repost. (n/m) posted by Kenny on June 18, 2006 at 01:42 PM
Message	How can you get a box end wrench on the fitting? (do you mean open end wrench?) ********************************************************* Joe GT675RS/Inconel AIM: hoyatiger81 "You probably never even got you hands dirty working on a car. Take care toolbox!" --djtz1
Follow Ups	As usual, simple Z procedure becomes difficult. - doug8867 11:43:34 06/17/06 vice grips. they sell metric unions, and compression - z324u 11:51:28 06/17/06 Torch? - Spddracer 11:52:11 06/17/06 Brass fittings are notorious for rounding up. - Jmartz 12:03:23 06/17/06 use vise grips to loosen it - ZEngineer 12:45:12 06/17/06 Box end wrench, mallet, tap on, loosen, enjoy. - Kenny 13:15:52 06/17/06 ...and then replace it. (n/m) - Kenny 13:23:12 06/17/06 File it down to the next smaller size - Joe(NoVA) 20:50:41 06/17/06 Repost. (n/m) - Kenny 13:42:56 06/18/06 You don't want to use a box end wrench. - Joe(NoVA) 18:44:51 06/18/06 Flare nut* - Kenny 21:12:19 06/18/06 Thanks for all the suggestions. (n/m) - doug8867 10:12:52 06/18/06
Post a Followup	You cannot reply to this message because you are not logged in.