TwinTurbo.NET: Nissan 300ZX forum - I use brake; when rpms get to like 1-1.5 I put in clutch and
People Seeking Info
 
   


     
Subject I use brake; when rpms get to like 1-1.5 I put in clutch and
     
Posted by CollegeBoy (Back in Kauai) on June 14, 2006 at 10:27 PM
  This message has been viewed 36 times.
     
In Reply To Question About Downshifting in the Z... Like Coming to a Sto posted by Farkel on June 14, 2006 at 06:35 PM
     
Message put car in neutral. Now if im doing a sudden stop i don't let the brakes pull the engine down, instead I push the clutch and brake and put the car in neutral all at the same time. Engine goes to 1k automatically and the car slows down fast without any strain on the engine. this is ONLY if it's a sudden stop. If it's a normmal stop, then I just leave it in gear till it gets low as stated above.

Thanks,
Mike
1991 Black Twin Turbo (Show AND Go)

there is no finished product - Spee 12:38:26 05/17/06

w00t!

---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that

"felt wierd fingering my exhuast for 1hr with no results :(" - zboost
"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21

If you care, here is my myspace
La-Z-Link

La-Z-Link
^^Hard engine break in method^^

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.