Subject	what i did was...
Posted by	spyhunterTT(nj) on June 11, 2006 at 4:32 PM
	This message has been viewed 33 times.
In Reply To	Bushing on end of Auto crankshaft? posted by wilkendw on June 11, 2006 at 04:23 PM
Message	I took the end of a pulley puller that just fit inside the hole, then used a hammer to work out the bushing...i.e. using the claw on the puller to pull out the bushing Alex
Follow Ups	Bushing on end of Auto crankshaft? - wilkendw 16:23:30 06/11/06 it comes off...you have to give it hell though. (n/m) - Spee 16:32:22 06/11/06 what i did was... - spyhunterTT(nj) 16:32:40 06/11/06 Just like removing a crank gear. Cut with dremel or - Spddracer 20:37:38 06/11/06 here is the easiest way, home depot style - FANTAZ(Power Supply Racing) 16:19:38 06/12/06
Post a Followup	You cannot reply to this message because you are not logged in.