TwinTurbo.NET: Nissan 300ZX forum - Hawk pads... HPS vs. HP+
People Seeking Info
 
   


     
Subject Hawk pads... HPS vs. HP+
     
Posted by zboost(tx) on June 10, 2006 at 3:59 PM
  This message has been viewed 137 times.
     
     
Message My pads have about 2 more months left in them and I currently have HPS.

I will be honest and say that the HPS just don't do it for me. Initial bite is very poor and I can't even make my ABS work most of the time.... and no it's not air in the lines.

I previously had Axxis ultimates and they were badass, only thing was they were dusty as hell.

Has anybody switched from HPS to HP+? How is the inital bite? Im not concerned about noise.




BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :)
stock turbos/injectors


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.