Subject	awesome kit, but..........
Posted by	jalohafan on May 30, 2006 at 9:07 AM
	This message has been viewed 46 times.
In Reply To	Take a look at the 300deg kit sometime posted by TTFairladyZ on May 30, 2006 at 07:30 AM
Message	I thought the purpose of machining the older style lower plenum was to properly align the new style injectors as to not affect the spray pattern. Am I mistaken?
Follow Ups	Fuel Injector Recommendations Now-a-Days... - Jason(IL) 06:46:04 05/30/06 Take a look at the 300deg kit sometime - TTFairladyZ 07:30:11 05/30/06 awesome kit, but.......... - jalohafan 09:07:13 05/30/06 no, the purpose of machining the lower plenum is so - Guapo 09:33:25 05/30/06 so what ur sayin is if u get the 300 degree fuel rail - traydogg6969(Pittsburgh) 13:29:23 05/30/06 correct (n/m) - drmx 13:49:40 05/30/06 Agreed. Pick up the 300 Degree fuel rails. I'm awaiting - whitepearlz 08:04:24 05/30/06 I went with 740's and a machined lower plenum... - drmx 13:53:47 05/30/06 Only very little extra labor if you're doing a 60K at the - Only1Z 20:41:36 05/30/06 yup, 120k and all that at the same time wasn't bad... - drmx 00:47:45 05/31/06 Re: Fuel Injector Recommendations Now-a-Days... - Jason(IL) 15:47:10 05/30/06
Post a Followup	You cannot reply to this message because you are not logged in.