Subject	that wing was a complete bitch to fit
Posted by	ZEngineer on May 19, 2006 at 2:43 PM
	This message has been viewed 43 times.
In Reply To	did you have problems fitting that kaminari wing? posted by Shawn300zTT GT28R MD on May 19, 2006 at 02:00 PM
Message	the edge didn't line up, so I had a piece of fiberglass molded to extend the wing about 1" down to meet the hatch edge. READ THIS _________________________________________________________________________________ "The Z is the cause and the solution to all my problems" -- Me manstretch: well, my rear end is just worn out ZEngineer24: sig quote
Follow Ups	ash-tray - supersayianjim 11:49:05 05/19/06 Perhaps. This might be the perfect opportunity for the - 240Z FeO2 11:56:45 05/19/06 One that converts to a cup holder. (n/m) - TT-Z 12:08:06 05/19/06 There you go. He could call it the MASSIVE Ashspec ashtray. (n/m) - 240Z FeO2 12:13:18 05/19/06 lol (n/m) - Shawn300zTT GT28R MD 13:16:25 05/19/06 extra heavy smokers need love too (n/m) - ZEngineer 13:29:14 05/19/06 did you have problems fitting that kaminari wing? - Shawn300zTT GT28R MD 14:00:21 05/19/06 that wing was a complete bitch to fit - ZEngineer 14:43:21 05/19/06 thanks man... - Shawn300zTT GT28R MD 14:59:47 05/19/06 I have the cup hold and I'll - boostedzxtt 12:15:17 05/19/06 In general, parts for the Z32 are more expensive than - Zirvana 13:03:26 05/19/06 God sells LOTS of ashtrays on ebay - WAGGZ 16:08:29 05/19/06
Post a Followup	You cannot reply to this message because you are not logged in.