Subject	I had trouble with mine.
Posted by	pieboy100 on May 16, 2006 at 2:22 PM
	This message has been viewed 20 times.
In Reply To	Z1/ Howe Rad mounting... posted by TWNSPIN on May 15, 2006 at 06:42 PM
Message	It was hard to install it down in the frame. It would not fit between the turbo hard pipes on the sides. I just has to push it against the passenget side and force it over to get it past the pipes. I hope I wont have to remove it any time soon. By the way the stock rad fit wiht no problems. And somthing else I noticed about the lower mount pins one side had a fillet weld on the bottom sibe of the pin and the other side had no fillet, so actually it sits up out of the rubber dounut about a 1/4 inch on the side with the fillet weld. Don't know if they just forgot to weld one side or if they did an extra weld on that side?
Follow Ups	Z1/ Howe Rad mounting... - TWNSPIN 18:42:55 05/15/06 We've installed at least 100 and never had that problem. - Russell@Z1 18:51:05 05/15/06 Does Z1 have any brackets specifically for the Howe Rad? (n/m) - jzee32tt 08:51:19 05/16/06 I actually have some samples on my desk for test fitting. - Russell@Z1 09:42:12 05/16/06 You missed something. (n/m) - 300twinz (satx) 18:56:13 05/15/06 Go below the car and make sure the two pins on each - zboost(tx) 19:28:31 05/15/06 I checked that already - TWNSPIN 20:43:19 05/15/06 Measure the radiator... - Shawn300zTT GT28R MD 11:19:50 05/16/06 I had trouble with mine. - pieboy100 14:22:17 05/16/06
Post a Followup	You cannot reply to this message because you are not logged in.