Subject	Go below the car and make sure the two pins on each
Posted by	zboost(tx) on May 15, 2006 at 7:28 PM
	This message has been viewed 25 times.
In Reply To	Z1/ Howe Rad mounting... posted by TWNSPIN on May 15, 2006 at 06:42 PM
Message	side of the radiator are sitting inside the rubber holes. Chances are it is not mounted right. BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :) stock turbos/injectors "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Z1/ Howe Rad mounting... - TWNSPIN 18:42:55 05/15/06 We've installed at least 100 and never had that problem. - Russell@Z1 18:51:05 05/15/06 Does Z1 have any brackets specifically for the Howe Rad? (n/m) - jzee32tt 08:51:19 05/16/06 I actually have some samples on my desk for test fitting. - Russell@Z1 09:42:12 05/16/06 You missed something. (n/m) - 300twinz (satx) 18:56:13 05/15/06 Go below the car and make sure the two pins on each - zboost(tx) 19:28:31 05/15/06 I checked that already - TWNSPIN 20:43:19 05/15/06 Measure the radiator... - Shawn300zTT GT28R MD 11:19:50 05/16/06 I had trouble with mine. - pieboy100 14:22:17 05/16/06
Post a Followup	You cannot reply to this message because you are not logged in.