TwinTurbo.NET: Nissan 300ZX forum - If you still have room for the wheels to fit under the fende
People Seeking Info
 
   


     
Subject If you still have room for the wheels to fit under the fende
     
Posted by CollegeBoy on May 03, 2006 at 10:14 AM
  This message has been viewed 30 times.
     
In Reply To so just gring the rear hub down .. can i just get a spacer? posted by 300zdett(nj) on May 03, 2006 at 09:24 AM
     
Message r with a spacer, then a spacer will be fine. Just be sure to get hubcentric ones as well as longer wheel studs. The best thing though would be to exchange for a properly fitting wheel.

Thanks,
Mike
1991 Black Twin Turbo (Show AND Go)

If you give two crappers,then this is about me...
La-Z-Link
^^Link made special just for member GoldZ =)^^
La-Z-Link
^^Hard engine break in method^^

NOT DONE! UGH!

---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that

"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.