TwinTurbo.NET: Nissan 300ZX forum - One more question Brett
People Seeking Info
 
   


     
Subject One more question Brett
     
Posted by zboost(tx) on April 25, 2006 at 3:10 PM
  This message has been viewed 153 times.
     
In Reply To 6-speed transmission swap posted by LitlElvis on April 25, 2006 at 12:06 AM
     
Message If you were to develop the adapter and related hardware would one be able to use any regular T-56 for example or would you have to use the richmond ROD? Reason I ask is because you could find a nice good T-56 off a camaro or vette for below $1800 where as that richmond is close to $3000.

I will contact RPS clutch to see if it's possible for them to put a new spline in my clutch discs since I would really like to keep my RPS carbon-carbon :) I believe they already make an application for the viper so perhaps I could use those discs if they're the same diameter.

Either Im happy you are going to go deep in this.
thanks




BEST 1/4mile 11.92 @ 117mph. PUMP gas, true 11 sec. street car :)
stock turbos/injectors


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.