Subject	so basically, it whether I set it to 1 or 6
Posted by	ZEngineer on April 24, 2006 at 4:34 PM
	This message has been viewed 24 times.
In Reply To	here's my wild guess posted by SactoTodd on April 24, 2006 at 03:53 PM
Message	that shouldn't affect the critical settings like A/F ratio, at most it would screw up the RPM signal for example. _________________________________________________________________________________ "The Z is the cause and the solution to all my problems" -- Me manstretch: well, my rear end is just worn out ZEngineer24: sig quote
Follow Ups	S-AFC2 settings question - ZEngineer 12:21:30 04/24/06 Canadian Conversion Rate (n/m) - Smitytec 12:25:11 04/24/06 Follow the insturctions. (n/m) - Spongerider :) 12:45:34 04/24/06 instructions are not clear, that's why I asked the question - ZEngineer 15:05:59 04/24/06 Does it specify chassis codes (i.e., Z33) with that? - boileralum 13:49:52 04/24/06 they mention Fairlady Z, Z33 and CPV35, whatever that is. (n/m) - ZEngineer 14:35:21 04/24/06 I'd stick with 6 then - I think the cars they are refering - boileralum 15:23:54 04/24/06 that's what my gut's telling me as well - ZEngineer 15:25:13 04/24/06 The setting labels on their electronics are always - boileralum 15:45:36 04/24/06 here's my wild guess - SactoTodd 15:53:02 04/24/06 so basically, it whether I set it to 1 or 6 - ZEngineer 16:34:11 04/24/06 the fuel settings are based on throttle position and RPM - Guapo 16:39:51 04/24/06 trying my best - SactoTodd 20:37:40 04/24/06 understood, thanks (n/m) - ZEngineer 21:57:25 04/24/06 CPV35 = g35 coupe/2 door skyline. (n/m) - Halo Z 18:30:47 04/24/06 6 (n/m) - DVDBURN (MD) 15:15:31 04/24/06 Hey George you need to set it to 6. I was confused - Riddick 16:50:25 04/24/06 thanks for the confirmation, I'll be setting it to 6 - ZEngineer 17:31:56 04/24/06 Re: S-AFC2 settings question - Fuzznutz 05:40:02 04/25/06
Post a Followup	You cannot reply to this message because you are not logged in.