| If anyone is interested I have templates I can use to make more of these glovebox inserts for holding gauges and such. I'm not sure what they would be worth. It takes a little fabing to make each one by hand. I can make them either clear or tinted. Here are some pics of the tinted templates installed in my "work in progress" NA Z. 
Some glare in this picture.
 
The two types. Clear and tinted.
 They are drop in and easy to support. In the yellow circle is where a screw which is part of the glovebox is located. A washer is added to increase the length of the screw a little to add extra support for this corner. In the green circles are the same screws and spacers that help hold the door panels but something else can be used here. They just help hold the insert in place. The inside slope of the front of the glovebox supports the insert from falling inside. The corner in the blue circle is supported by the natural curve of the glovebox as the glovebox makes an outward curve in that corner right below the top level of the glovebox.
 If interested send me an email.
www.mytwinturbo.com
I think I speak for most when I say "We don't give 2 sh!ts" (n/m) - YugoBernie (NoVA) 11:40:06 01/15/03 (4) |
Glovebox insert. - 
