Subject	i had the same problem on the 90 na i worked on,
Posted by	Halo Z on April 23, 2006 at 1:04 PM
	This message has been viewed 33 times.
In Reply To	Need to vent after a long day...... posted by SZ32R(Hawaii) on April 23, 2006 at 04:46 AM
Message	while prying the crack sprocket off, i cracked the caseing to the oil pump. pulled the motor, replaced it, cleaned up the motor and dropped it back in. ________________________________________________________ RIC, my spelling sux, deal with it. 90 Z32 NA 93 Z32 NA 93 240sx coupe 01 D22 SE DR
Follow Ups	Need to vent after a long day...... - SZ32R(Hawaii) 04:46:04 04/23/06 Re: Need to vent after a long day...... - MidLifeZ 06:37:26 04/23/06 With all the covers and everything back in place it's really - SZ32R(Hawaii) 06:46:51 04/23/06 VTC orings? (n/m) - YugoBernie (NoVA) 08:33:44 04/23/06 2nd - MidLifeZ 08:44:14 04/23/06 3rd. (n/m) - zx spinner 08:54:04 04/23/06 When the VTC o-rings were installed (new) -- you - jzack 09:27:55 04/23/06 None of the gaskets or o-rings were re-used as I'm aware - SZ32R(Hawaii) 01:16:55 04/24/06 Try leaving your driverside T-belt cover off - TTFairladyZ 09:31:15 04/23/06 He can also just start the engine once the timing belt is on - zx spinner 09:54:15 04/23/06 He said he had it running for about 1min before it started - TTFairladyZ 10:04:27 04/23/06 one minute is fine at idle (n/m) - SpecNATT (Houston) 12:38:28 04/23/06 Re: With all the covers and everything back in place it's really - SpecNATT (Houston) 12:42:15 04/23/06 Just wanted to add - zx spinner 09:05:48 04/23/06 Yes, I had a bad feeling about changing the gaskets, but was - SZ32R(Hawaii) 01:22:22 04/24/06 good luck, bookmarked for future reference (n/m) - LJZTT 12:02:39 04/23/06 front crank seal in the front of the oil pump? - SpecNATT (Houston) 12:32:46 04/23/06 i had the same problem on the 90 na i worked on, - Halo Z 13:04:09 04/23/06
Post a Followup	You cannot reply to this message because you are not logged in.