Subject	I do not know to much about the subject but I know
Posted by	dream Z (MD) on April 18, 2006 at 10:13 AM
	This message has been viewed 22 times.
In Reply To	Anyone have any links or helpful info... posted by Shawn300zTT GT28R MD on April 18, 2006 at 02:43 AM
Message	a lot of the muscle car guys will cut out what is bad then replace it with a good piece buy welding it in place. But when welding go in a rotation starting with the welds far apart and then getting closer with each rotation which will help with not warping the metal. After that use a hammer and dolley to make all the high and low spots go away as the metal will wrinkle up a little Then sand the welds down so you have a smooth surface for primer and paint.
Follow Ups	Anyone have any links or helpful info... - Shawn300zTT GT28R MD 02:43:50 04/18/06 C'mon now... I know some of you have to have experience - Shawn300zTT GT28R MD 09:00:59 04/18/06 I do not know to much about the subject but I know - dream Z (MD) 10:13:08 04/18/06
Post a Followup	You cannot reply to this message because you are not logged in.