Subject	They have phillips head and they have hex head, but not...
Posted by	MaxD on April 12, 2006 at 11:17 AM
	This message has been viewed 17 times.
In Reply To	http://www.mcmaster.com/ (n/m) posted by Barry'z (NJ) on April 12, 2006 at 09:00 AM
Message	together. Only phillips drive with pan, flat, and oval head. And only hex head with slotted or no drive. Not to mention no tapered thread. There must be a manufacturer who makes these.
Follow Ups	Where can I Buy M6 (6MM) screws/bolts? - MaxD 23:42:55 04/11/06 ACE Hardware, Home Depot (n/m) - rufflez 23:45:37 04/11/06 Re: ACE Hardware, Home Depot - MaxD 23:51:02 04/11/06 Re: Re: ACE Hardware, Home Depot - MaxD 23:52:09 04/11/06 Ah, OK. I haven't had to replace Z bolts, but thats where - rufflez 23:57:04 04/11/06 Buying bulk from the Nissan dealer is probably expensive. (n/m) - MaxD 23:59:43 04/11/06 it's not that expensive - aliaZ 11:07:29 04/12/06 Yeah, if he were closer, I'd buy em and sell them to him. - rufflez 11:56:33 04/12/06 Home Depots around me stock about 4 metric bolts. - BummedOutMonkey 09:05:02 04/12/06 I know right, ACE is so small, yet has a ton of useful tools - rufflez 10:13:39 04/12/06 www.fastenal.com - greyzx 00:07:07 04/12/06 Phillips drive but not hex head, just pan, flat, and oval. (n/m) - MaxD 00:27:35 04/12/06 Re: Where can I Buy M6 (6MM) screws/bolts? - jackaj 00:16:13 04/12/06 Hands down either Grainger or McMaster CARR (n/m) - Spectrum (WI) 07:49:03 04/12/06 which bolts are you specifically looking for? - spyhunter(nj) 08:47:29 04/12/06 No bolts with a 10mm head? Ha! Here is a quick one... - MaxD 11:10:01 04/12/06 uh... There's tons (n/m) - Waco300zx 12:03:01 04/12/06 hex head != allen head (n/m) - boileralum 12:37:46 04/12/06 doh i was thinking allen head, never mind (n/m) - spyhunter(nj) 21:19:22 04/12/06 http://www.mcmaster.com/ (n/m) - Barry'z (NJ) 09:00:31 04/12/06 2nd...they have almost everything when it comes to hardware (n/m) - Atl300zxTT (Extremely Lazy) 09:16:55 04/12/06 They have phillips head and they have hex head, but not... - MaxD 11:17:29 04/12/06 Fuzzy image of one of the short bolts: - MaxD 11:23:00 04/12/06
Post a Followup	You cannot reply to this message because you are not logged in.