TwinTurbo.NET: Nissan 300ZX forum - Re: just ordered the valentine v1
People Seeking Info
 
   


     
Subject Re: just ordered the valentine v1
     
Posted by wallerwc on April 10, 2006 at 12:09 AM
  This message has been viewed 138 times.
     
In Reply To just ordered the valentine v1 posted by jt12203 on April 09, 2006 at 04:06 PM
     
Message I just recently had to replace the original straight "Phone" power cord (got a 7 foot, at walmart, black/gray, matches interior, works fine) on my Valentine, I had it installed/purchased since 1999. The little "click to hold" piece broke off the phone cord connector, guess due to heat/cold and usage. My install, I ran the straight power cord from the fuse box kick panel, hide behind the a-pillar along the winshield, and up to the Sun viser. I use the clip bracket (not the suction cups) on the V1 to attach to the sun viser, with sun viser up. Also, if the sun is in my face (driving), since I wound the extra length of phone power cord around the driver sun viser metal pivot connector, I can wind further length out if I want, and move/clip the V1 to the passenger sun viser if I need to put the Driver sun viser down (the V1 is clipped to the Pass sun viser) I glued a little velcro piece above the sun visor to hold the power cord in place, if I lower the viser. I can post a pic if this is confusing, or if anyone cares.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.