TwinTurbo.NET: Nissan 300ZX forum - Set everything to 0. Adjust duty cycle from 40~60
People Seeking Info
 
   


     
Subject Set everything to 0. Adjust duty cycle from 40~60
     
Posted by zboost(tx) on March 27, 2006 at 8:41 AM
  This message has been viewed 270 times.
     
In Reply To settings for the greddy profec b spec II posted by 300zdett(nj) on March 27, 2006 at 12:17 AM
     
Message start at about 40 and see what boost that gives you, set your warning to whatever psi you want (16 on stock injector and pump gas) and limiter to 10%. Don't mess with the gain crap as it will always spike.

You will have to adust duty cycle constantly with the weather changes outside. Example it's 30degrees right know and you have 15psi, tomorrow it's 70 and you might only have 13 or 12 psi.


BEST 1/4mile 11.92 @ 117mph.
stock turbos/injectors


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.