Subject	for those of you that have installed widebands...
Posted by	aliaZ on March 21, 2006 at 11:24 PM
	This message has been viewed 76 times.
Message	What is the best way to route the O2 sensor cables into the car? This is for a permanent installation. Thanks
Follow Ups	for those of you that have installed widebands... - aliaZ 23:24:57 03/21/06 You can put a hole & a rubber grommet into the floor pan. - YugoBernie (NoVA) 23:35:17 03/21/06 what is the OD of this grommet? - aliaZ 00:09:25 03/22/06 Larger then 1" so that the connector can pass. (n/m) - YugoBernie (NoVA) 00:18:21 03/22/06 courtesy claims the grommet is only sold with the sensor (n/m) - aliaZ 15:47:48 03/22/06 Im sure you can get something off the shelf @ Lowes. - YugoBernie (NoVA) 17:34:07 03/22/06 lowes didn't have much. - aliaZ 22:05:02 03/22/06 They have them in the electrical section and the "bins" (n/m) - YugoBernie (NoVA) 22:28:16 03/22/06 I checked in those two areas - aliaZ 06:51:50 03/23/06 My wideband is in the stock o2 location - EricTTZ 23:43:30 03/21/06 Same. (n/m) - MarkA(NoVA) 09:49:58 03/22/06 I ran mine down by the shifter (n/m) - luke21 02:29:48 03/22/06 I bought a handfull of these... - ni[X]it 08:23:30 03/22/06 Email workie again? Copy me. (n/m) - Scotts94z32 10:11:44 03/22/06 me too..... (n/m) - BOOZTD 3 (the original) 10:25:33 03/22/06 thanks nick - aliaZ 15:46:41 03/22/06
Post a Followup	You cannot reply to this message because you are not logged in.