Subject	UPDATE:>>.>>>>>>>
Posted by	zboost(tx) on March 19, 2006 at 7:52 PM
	This message has been viewed 49 times.
In Reply To	Guys with Profec B Spec2>>> Solenoid longetivity>>>> posted by zboost(tx) on March 19, 2006 at 02:04 PM
Message	Solenoid= DEAD Routed my boost side line to the wastegates.... sure enough boost didn't go above 7.5psi.... :) Hooked them back up to the solenoid, boost went to 21 psi...(fun as crap though! :) The solenoid clicks, but apparently something is screwed up, o well. Thanks guys!! Search words: Greddy solenoid Apex i apexi actuator wastegate actuators high boost stuck open closed BEST 1/4mile 12.16 @ 112mph. "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Guys with Profec B Spec2>>> Solenoid longetivity>>>> - zboost(tx) 14:04:51 03/19/06 do you have the first generation with the smaller - MOZZ 14:08:14 03/19/06 Hmmm..... not sure.> - zboost(tx) 15:15:12 03/19/06 that's the newer solenoid... - ni[X]it 15:34:04 03/19/06 Here's a pic of mine.. - zboost(tx) 15:57:33 03/19/06 FWIW - BOOZTD 3 (the original) 19:14:35 03/19/06 fwiw - mousersix (San Antonio) 14:29:52 03/19/06 srry but where is the right up that you used to hook it up?? - 300zdett(nj) 14:43:36 03/19/06 I just read the directions with the BC :) (n/m) - zboost(tx) 15:00:29 03/19/06 No problems with mine so far. If anything, I would have - olyar15 18:44:55 03/19/06 UPDATE:>>.>>>>>>> - zboost(tx) 19:52:17 03/19/06 well that sucks.. add another one to the list - MOZZ 21:13:48 03/19/06 Yea, profec2 and type S use the same solenoid. - zboost(tx) 22:12:59 03/19/06 Re: Guys with Profec B Spec2>>> Solenoid longetivity>>>> - Fuzznutz 06:10:10 03/20/06 And I just read your update... (n/m) - Fuzznutz 06:12:05 03/20/06
Post a Followup	You cannot reply to this message because you are not logged in.