TwinTurbo.NET: Nissan 300ZX forum - Guys with Profec B Spec2>>> Solenoid longetivity>>>>
People Seeking Info
 
   


     
Subject Guys with Profec B Spec2>>> Solenoid longetivity>>>>
     
Posted by zboost(tx) on March 19, 2006 at 2:04 PM
  This message has been viewed 96 times.
     
     
Message I'm having a problem with my boost controller, I recently mounted it where my battery was along with my Water injection stuff to keep the lines shorter, well today my car was boosting to about 18psi with my boost controller off... Checked my wastegate lines and everything is good, no loose connections anywhere.
Could the heat have killed the solenoid? It still clicks though, so it's does something. But it doesnt matter if I turn it off or set it to high boost the turbos will boost out of control. Luckily I run water/methanol injection full time, so I get no detonation.
Any complaints on the solenoids?


BEST 1/4mile 12.16 @ 112mph.


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.