Subject	certainly don't look near the quality of my heads
Posted by	bankruptedz on March 19, 2006 at 1:24 AM
	This message has been viewed 76 times.
In Reply To	Porting guys.....hows this look? posted by BOOZTD 3 (the original) on March 18, 2006 at 02:17 AM
Message	which were done by west coast heads in CA ([ www.proheads.com ]). There is more meat in the mid runner section removed on mine, the knife edge on the split is more dramatic and the surface finish is much more consistant. Also it not always the amount of material you remove but where you remove it from. Good luck!
Follow Ups	Porting guys.....hows this look? - BOOZTD 3 (the original) 02:17:35 03/18/06 Make sure you leave the intake ports rough. More pics :) (n/m) - CrazyGreek 02:23:31 03/18/06 ive read mixed reviews on this... - BOOZTD 3 (the original) 02:30:54 03/18/06 Are you going to swirl polish that to smooth it out? - Turnerscasa (Dallas) 07:56:02 03/18/06 Kinda late, but have you seen this? - NytWolf 10:48:44 03/18/06 Warning: speculation inside..even assuming his theory is - whatsthegoodword 16:01:07 03/18/06 lol. (n/m) - nixit 16:33:59 03/18/06 you should use a carbide burr to get the material - Shawn300zTT GT28R MD 12:35:27 03/18/06 Are you going to gasket match the ports? - DAYTONAZ 15:52:49 03/18/06 Re: Porting guys.....hows this look? - Chadman 16:36:31 03/18/06 like crazy geek said leave the intake ports kind of rough - suprakillinz 21:50:05 03/18/06 certainly don't look near the quality of my heads - bankruptedz 01:24:49 03/19/06
Post a Followup	You cannot reply to this message because you are not logged in.