Subject	Jon Abeler is producing a second generation set of his
Posted by	Ash's Z on March 12, 2006 at 8:51 PM
	This message has been viewed 98 times.
In Reply To	TT manifolds, do I wait for the MS ones? posted by method on March 12, 2006 at 08:05 PM
Message	cast iron manifolds that will not require relocation of a manifold stud. I'm not exactly sure when they are going to be available in full production, but I know it will be very soon. [ ashspecz.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	TT manifolds, do I wait for the MS ones? - method 20:05:31 03/12/06 Magic 8-Ball says, "Ask again later." (n/m) - dpjax 20:32:59 03/12/06 Jon Abeler is producing a second generation set of his - Ash's Z 20:51:27 03/12/06 cast vs inconel - Shawn Lane(NO VA) 20:56:04 03/12/06 lol - aliaZ 21:34:55 03/12/06 Re: cast vs inconel - method 03:09:09 03/13/06 Ugh. (n/m) - RSR 07:12:26 03/13/06 lol. seriously. lol. - ni[X]it 08:22:48 03/13/06 Just let it go man there is more to life than being - Shawn Lane(NO VA) 18:58:21 03/13/06 rofl - Spee 00:05:11 03/14/06 depends on your timeline - aliaZ 21:46:52 03/12/06 >>> - ztunerz 21:59:46 03/12/06 >>>> - aliaZ 22:15:05 03/12/06 I wholeheartedly agree that making them truly "bolt on" - lil'abner 22:19:38 03/12/06 Take all this with a grain of salt... - dpjax 05:52:29 03/13/06 yawn - aliaZ 09:03:16 03/13/06 Re: depends on your timeline - ni[X]it 08:25:46 03/13/06 sigh - ztunerz 23:32:11 03/13/06 remember those flow bench numbers you posted on 300zxclub? - ni[X]it 12:15:35 03/14/06 yeah >. they were close to or higher than GD >> - ztunerz 21:41:27 03/14/06 Inconels = sexy :-) - Joe(NoVA) 22:03:04 03/12/06 Mike Smith manifolds - bankruptedz 00:16:31 03/13/06 Welcome to the club Maybe I should start on the tee shirts - Tony@GZperformance 07:48:22 03/13/06 Re: Welcome to the club Maybe I should start on the tee shir - method 15:08:15 03/13/06
Post a Followup	You cannot reply to this message because you are not logged in.