Subject	Re: JDM emblem center point.
Posted by	tjlazer on March 11, 2006 at 11:38 PM
	This message has been viewed 40 times.
In Reply To	JDM emblem center point. posted by DVDBURN (MD) on March 11, 2006 at 07:58 PM
Message	I just did this today on my 90 nose panel! I just snipped off the legs with a small wire cutter worked great.
Follow Ups	JDM emblem center point. - DVDBURN (MD) 19:58:30 03/11/06 looks great, gonna sell me one of those =) (n/m) - Max865(ATL) 20:18:07 03/11/06 my center panel came with a hole in it for the emblem - SpecNATT (Houston) 20:23:00 03/11/06 Cool. You just gave me an idea. :) (n/m) - Ash's Z 20:30:27 03/11/06 playing around with those camera options aren't yah :-P (n/m) - ben_96_slicktop (nova) 20:48:59 03/11/06 why do you have two? (n/m) - tyler@boostpro.net 21:25:40 03/11/06 I found two for less than I usually see one go for so I - DVDBURN (MD) 23:52:54 03/11/06 Quick question - 92fairladyz (Yokosuka, Japan) 22:15:17 03/11/06 Easy, sand down the pegs behind the emblem. - SpdDemon13 (Japan) 23:21:22 03/11/06 mm? .... - SpdDemon13 (Japan) 23:18:10 03/11/06 Re: mm? .... - DVDBURN (MD) 23:35:37 03/11/06 I think you meant cm (not mm) in your measurements :) - SpdDemon13 (Japan) 23:54:42 03/11/06 You're absolutely correct. My fault, thanks :) (n/m) - DVDBURN (MD) 00:00:13 03/12/06 . - Milo (San Antonio) 23:21:24 03/11/06 The question was brought up a few weeks ago without - DVDBURN (MD) 23:33:59 03/11/06 Can't a guy take a vacation from this site? - Milo (San Antonio) 23:41:20 03/11/06 Re: JDM emblem center point. - tjlazer 23:38:14 03/11/06 Correction. The measurements are centimeters not milimeters. - DVDBURN (MD) 00:05:26 03/12/06 cool,. Thanks... saves us some time.. - Shawn300zTT GT28R MD 02:51:02 03/12/06
Post a Followup	You cannot reply to this message because you are not logged in.