Subject	Easy, sand down the pegs behind the emblem.
Posted by	SpdDemon13 (Japan) on March 11, 2006 at 11:21 PM
	This message has been viewed 35 times.
In Reply To	Quick question posted by 92fairladyz (Yokosuka, Japan) on March 11, 2006 at 10:15 PM
Message	I had the Stillen louvered panel on my old Z with the Z emblem. Afermarket panels do not have the indentations so the simplest thing to do is just cut off or sand down the pegs behind the emblem and very carefully put it on. And make sure it's right side up... I've seen a couple cases where people put the emblem on upside-down :) Harry 1996 J-Spec 2+2 Twin Turbo (RHD) 1992 Z Twin Turbo - SOLD! 2002 Subaru Impreza WRX - SOLD! 1993 Honda Prelude VTEC - SOLD! "OMG! I'm going straight to HELL!!!!" - Wolf [Pittsburgh]
Follow Ups	JDM emblem center point. - DVDBURN (MD) 19:58:30 03/11/06 looks great, gonna sell me one of those =) (n/m) - Max865(ATL) 20:18:07 03/11/06 my center panel came with a hole in it for the emblem - SpecNATT (Houston) 20:23:00 03/11/06 Cool. You just gave me an idea. :) (n/m) - Ash's Z 20:30:27 03/11/06 playing around with those camera options aren't yah :-P (n/m) - ben_96_slicktop (nova) 20:48:59 03/11/06 why do you have two? (n/m) - tyler@boostpro.net 21:25:40 03/11/06 I found two for less than I usually see one go for so I - DVDBURN (MD) 23:52:54 03/11/06 Quick question - 92fairladyz (Yokosuka, Japan) 22:15:17 03/11/06 Easy, sand down the pegs behind the emblem. - SpdDemon13 (Japan) 23:21:22 03/11/06 mm? .... - SpdDemon13 (Japan) 23:18:10 03/11/06 Re: mm? .... - DVDBURN (MD) 23:35:37 03/11/06 I think you meant cm (not mm) in your measurements :) - SpdDemon13 (Japan) 23:54:42 03/11/06 You're absolutely correct. My fault, thanks :) (n/m) - DVDBURN (MD) 00:00:13 03/12/06 . - Milo (San Antonio) 23:21:24 03/11/06 The question was brought up a few weeks ago without - DVDBURN (MD) 23:33:59 03/11/06 Can't a guy take a vacation from this site? - Milo (San Antonio) 23:41:20 03/11/06 Re: JDM emblem center point. - tjlazer 23:38:14 03/11/06 Correction. The measurements are centimeters not milimeters. - DVDBURN (MD) 00:05:26 03/12/06 cool,. Thanks... saves us some time.. - Shawn300zTT GT28R MD 02:51:02 03/12/06
Post a Followup	You cannot reply to this message because you are not logged in.