Subject	It could be your valves or rings. pour some oil and
Posted by	AzHeat on March 11, 2006 at 6:53 PM
	This message has been viewed 31 times.
In Reply To	Did routine maintence and a compression check. should posted by upcominZ_2+2TT on March 11, 2006 at 06:14 PM
Message	do it again . If the compression goes up then it is the rings. If it doesn't change then it is the valves. If it is the valves . It could be your lifters are sticking the valves open and not bleeding allowing them to seat.
Follow Ups	Did routine maintence and a compression check. should - upcominZ_2+2TT 18:14:47 03/11/06 And, for those who saw the post about my 1/4mi time, - upcominZ_2+2TT 18:18:35 03/11/06 14psi maximum deviation from any two cylinders. - Ash's Z 18:31:17 03/11/06 I don't have the gms chip in. I'm using the jdm auto ecu - upcominZ_2+2TT 18:38:00 03/11/06 I misread your post, sorry. You mentioned - Ash's Z 19:10:19 03/11/06 I'm not comfortable with >10% difference among cylinders (n/m) - lil'abner 18:32:28 03/11/06 It could be your valves or rings. pour some oil and - AzHeat 18:53:48 03/11/06 Read again, his #'s are excellent. (n/m) - ZyaL8r 21:20:18 03/11/06
Post a Followup	You cannot reply to this message because you are not logged in.