TwinTurbo.NET: Nissan 300ZX forum - Sadly, my Kuruma wing
People Seeking Info
 
   


     
Subject Sadly, my Kuruma wing
     
Posted by CollegeBoy on March 05, 2006 at 3:44 PM
  This message has been viewed 85 times.
     
In Reply To Don't do it, there were a few posts of how crappy they fit posted by dregos on March 05, 2006 at 03:36 PM
     
Message doesn't fit so great. We put it on the Z, and there are only two screw points on the wing, with no clip points...it needs more. That would be great if it fit perfetly, but it doesn't. Unfortunatley the sides of the wing are both about a good 1/4 inch raised from the edge of the trunk even when pressed down on. Also, the back of it sticks about 1/4 inch farter than it should. Both of these issues will be addressed by simply sanding the inside of the wing a lot in some areas we hope and by adding clip points to use existing clip points on the trunk lid. But at a normal body shop it can be like $50 an hour of more for labor and with this taking a few hours to do, thats not very sweet for a $450 wing. Just a heads up for some issues to be fixed on this wing that was supposed to fit perfectly. Hopefully they can be fixed cause that company appears to be a great one so far in out community.

Thanks,
Mike
1991 Black Twin Turbo (Show AND Go)

If you give two crappers,then this is about me...
La-Z-Link
^^Link made special just for member GoldZ =)^^
La-Z-Link
^^Hard engine break in method^^

---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that

"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.