Subject	Bummer, someone just drove off like that. Good Luck! (n/m)
Posted by	giotx on March 05, 2006 at 9:05 AM
	This message has been viewed 19 times.
In Reply To	Gotta question about rear "fender" posted by Waco300zx on March 04, 2006 at 01:27 PM
Message
Follow Ups	Gotta question about rear "fender" - Waco300zx 13:27:26 03/04/06 Much more cost effective to pull the dent out and then fill - RDQ LUZ 13:35:13 03/04/06 so the whole piece has to be cut out all the way around - Waco300zx 13:48:43 03/04/06 not all the way around the car. - ssm300z 13:52:05 03/04/06 Just went outside for ya :P - Cincyzx 01:38:13 03/05/06 Did you mean to reply to me? - ssm300z 15:31:34 03/05/06 Re: Gotta question about rear "fender" - ZNoob 13:39:59 03/04/06 washed the car... - Waco300zx 13:47:19 03/04/06 That dent can be pulled out with a stud welder. - BooZted 14:11:12 03/04/06 Yah, i had a dent pulled like that in my old jeep. - Waco300zx 14:26:36 03/04/06 $400? Just to spray and blend the area will be that much. (n/m) - Zluster(Sir Sam) 17:09:53 03/04/06 know some people ;) (n/m) - Waco300zx 17:29:26 03/04/06 same thing happened to me. BTW it's called a quarter panel. - apudapus 14:48:00 03/04/06 Yah i know it's a quater panel, but it's not - Waco300zx 14:59:42 03/04/06 It's welded right below the taillights (n/m) - Mickie 15:02:02 03/04/06 makes since now. thnx (n/m) - Waco300zx 15:33:51 03/04/06 Recent discussion on it I posted this pic - Mickie 15:40:28 03/04/06 Notice in my pic though, I don't have that. - Waco300zx 15:42:58 03/04/06 I know, just showing the location of the weld (n/m) - Mickie 15:44:37 03/04/06 Actually it has nothing to do with year.... - KevinsFairlady 09:33:48 03/05/06 I'd just get that fixed and not replace the entire quarter. (n/m) - Spddracer 14:53:42 03/04/06 Re: Gotta question about rear "fender" - WolfeZX 15:39:49 03/04/06 I'll leave it to professionals inthis instance. - Waco300zx 15:41:54 03/04/06 Bummer, someone just drove off like that. Good Luck! (n/m) - giotx 09:05:45 03/05/06
Post a Followup	You cannot reply to this message because you are not logged in.