Subject	hey, my friend spun a rod bearing, too,
Posted by	apudapus on March 04, 2006 at 7:39 AM
	This message has been viewed 24 times.
In Reply To	3 thousands is a good rule of thumb posted by Jared Todd on March 04, 2006 at 03:11 AM
Message	on his turbo GSR motor. he had forged pistons but i can't remember his clearance. the 3 cylinder walls looked alright. *********************************
Follow Ups	Not to pick a scab, but a question on Wiseco's - wilkendw 22:44:44 03/03/06 Ive been told 0.003" clearance. (n/m) - ZisLuv 23:37:54 03/03/06 the clearence depends on your hp goals.. - Shawn300zTT GT28R MD 02:41:03 03/04/06 sorry, didn't read your post fully... - Shawn300zTT GT28R MD 02:46:10 03/04/06 3 thousands is a good rule of thumb - Jared Todd 03:11:48 03/04/06 hey, my friend spun a rod bearing, too, - apudapus 07:39:33 03/04/06
Post a Followup	You cannot reply to this message because you are not logged in.