Subject	3 thousands is a good rule of thumb
Posted by	Jared Todd on March 04, 2006 at 3:11 AM
	This message has been viewed 34 times.
In Reply To	Not to pick a scab, but a question on Wiseco's posted by wilkendw on March 03, 2006 at 10:44 PM
Message	more for more power etc. I was running .006" on my honda with some SRPs and put almost 10k miles on them. They were a bit noisy but the noise went away after the engine warmed up. AFter blowing a rod bearing (worn out stock pump) i tore the motor down and the slugs still look fine. --------------------------------------------------- AIM= Honda Of Fury
Follow Ups	Not to pick a scab, but a question on Wiseco's - wilkendw 22:44:44 03/03/06 Ive been told 0.003" clearance. (n/m) - ZisLuv 23:37:54 03/03/06 the clearence depends on your hp goals.. - Shawn300zTT GT28R MD 02:41:03 03/04/06 sorry, didn't read your post fully... - Shawn300zTT GT28R MD 02:46:10 03/04/06 3 thousands is a good rule of thumb - Jared Todd 03:11:48 03/04/06 hey, my friend spun a rod bearing, too, - apudapus 07:39:33 03/04/06
Post a Followup	You cannot reply to this message because you are not logged in.