Subject	Not to pick a scab, but a question on Wiseco's
Posted by	wilkendw on March 03, 2006 at 10:44 PM
	This message has been viewed 72 times.
Message	I've spent the last two hours reading all the drama about these pistons, hopefully all the bile has been spat and this won't get flamed... just need some info for the shop. -what is the best/recommended clearance to avoid slap and blow-by at stage III? -do I need the NA squirters with these? -are the tapered wrist pins a good option or are they much weaker due to lighter? -aside from tolerances, any other details the shop needs to know? thanks
Follow Ups	Not to pick a scab, but a question on Wiseco's - wilkendw 22:44:44 03/03/06 Ive been told 0.003" clearance. (n/m) - ZisLuv 23:37:54 03/03/06 the clearence depends on your hp goals.. - Shawn300zTT GT28R MD 02:41:03 03/04/06 sorry, didn't read your post fully... - Shawn300zTT GT28R MD 02:46:10 03/04/06 3 thousands is a good rule of thumb - Jared Todd 03:11:48 03/04/06 hey, my friend spun a rod bearing, too, - apudapus 07:39:33 03/04/06
Post a Followup	You cannot reply to this message because you are not logged in.