TwinTurbo.NET: Nissan 300ZX forum - lol
People Seeking Info
 
   


     
Subject lol
     
Posted by zboost(tx) on February 28, 2006 at 8:35 PM
  This message has been viewed 37 times.
     
In Reply To sounds good posted by SactoTodd on February 28, 2006 at 08:22 PM
     
Message I could probably fab the adaptor plate easily in PRO/Engineer then find someone to cut it. But I don't consider myself "good enough" to do such a thing... :(
I imagine the driveshaft would be pretty easy (relatively speaking) and if I got luck and found one with taller gearing I would have no need for leader gears.... so kill 2 birds with one stone. then comes wiring the speedo/reverse light/ and whatever that third sensor in the tranny is. dammit im thinking to much... o crap I forgot the mount and crossmember.
Who knows, if my tranny takes a dump I might just tackle this afterall...


BEST 1/4mile 12.16 @ 112mph.


"yo yo. writing this one in jail - tight300zx"
I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04
we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04

"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.